Personal tools
You are here: Home Forum Use Partition of extruded face

Partition of extruded face

Up to Use

Partition of extruded face

Posted by Johan E at January 13. 2022
Hello, I have a task that should seem fairly simple, namely extrude a face (and thus create a solid) and partition this new solid using other faces. However, when I am performing the partition, the results turns out all wrong (random lines everywhere). I have attachted a script that you can run to reproduce the situation, and will post a few pictures below. I hope someone can help. Best, Johan
Attachments

Re: Partition of extruded face

Posted by Johan E at January 13. 2022
Picture of the extruded solid (grey) and the faces that are used for partitioning (blue), BEFORE partition is performed:
Attachments

Re: Partition of extruded face

Posted by Johan E at January 13. 2022
Picture of the resulting partition:
Attachments
Powered by Ploneboard
Document Actions