Personal tools
You are here: Home Forum Use Help needed to construct cap coating on spherical balls

Help needed to construct cap coating on spherical balls

Up to Use

Help needed to construct cap coating on spherical balls

Posted by Zohre Gorunmez at October 29. 2018

Hello,
I would like to construct thick coatings on the spheres I attached here in Figure 1. The final structure should have 10 spherical balls (sitting on a film) and each ball will have thick smooth coating as it is shown in Figure 2.

I would be happy for any recommendations here.

Re: Please see attached figures

Posted by Zohre Gorunmez at October 29. 2018

I am sorry for not posting the figures along with the original post.

Attachments

Figure 1

Posted by Zohre Gorunmez at October 29. 2018

Previously Zohre Gorunmez wrote:

I am sorry for not posting the figures along with the original post.

 

Attachments

Re: Help needed to construct cap coating on spherical balls

Posted by Sergio Pluchinsky at October 30. 2018
You could do a 2d mesh on the face of the ball and then extrude in element normal direction to have the 3d element. You can specify the thkness and quantity of element along the extrusion.
 
Regards

Re: Help needed to construct cap coating on spherical balls

Posted by Zohre Gorunmez at October 30. 2018

Hello,
I am not sure where to start actually. These balls are solid spheres. When I get their 'faces' by "Explode", these faces are already. Can you take a look at the hdf file if I send it to you? We can exchange e-mail accounts privately.

 

Previously Sergio Pluchinsky wrote:

You could do a 2d mesh on the face of the ball and then extrude in element normal direction to have the 3d element. You can specify the thkness and quantity of element along the extrusion.
 
Regards


 

Re: Help needed to construct cap coating on spherical balls

Posted by Sergio Pluchinsky at October 31. 2018

You can send the model to sergio.pluchinsky at gmail.com

Powered by Ploneboard
Document Actions