Personal tools
You are here: Home Forum Use Re: 2D mesh with viscous layer

Re: 2D mesh with viscous layer

Up to Use

Re: 2D mesh with viscous layer

Posted by Jean-Yves at December 13. 2017

Dear all,

 

I would like to make a 2D mesh (triangular or quadrilateral) of an external right angle.

To perform this, I use NETGEN 2D algorithm with the automatic length for the 1D hypothesis. Then I add a viscous layer on the two edges of my external right angle (see picture).

However, the mesh doesn't look good at the location iof the right angle.

So is it possible to improve this mesh. For example, in order to have rectangular faces everywhere in the viscous layer and thapezium (angle with a 45°) faces in the right  angle location, I would prefer distributing the 45° angle all over the edge along my geometry.

 

Thank you for your anwers.

 

JYves

Attachments

Re: 2D mesh with viscous layer

Posted by sheaker at December 27. 2017
Hello. I think You have to do it manually. Define additional edges and use wire discretization.
Powered by Ploneboard
Document Actions