Personal tools
You are here: Home Forum Use Can I create face from edges?

Can I create face from edges?

Up to Use

Can I create face from edges?

Posted by sheaker at December 27. 2017

Hello!

I'm using SALOME 8.3.0 for Windows.

I'm trying to create face out of four edges (or one wire) but some results are strange.

Edges:

https://zapodaj.net/images/40dca97cc9d78.jpg

Strange face created in SALOME:

https://zapodaj.net/images/85c6e513bcffa.jpg

Four out of eight similar faces are not properly create; other four are correct.

Can I do something to create correct face from those edges?

I whish you all best!

Sheaker

Re: Can I create face from edges?

Posted by Saint Michael at December 27. 2017

I can suggest trying other ways of creation, e.g. New Entity > Generation > Extrusion or > Filling.

St.Michael

Re: Can I create face from edges?

Posted by sheaker at December 27. 2017

Thank You for Your reply. Unfortunately I can't use >Extrusion because those lines aren't perfectly parallel. >Filling produce different, but still incorrect results.

I think I could do it in this way:

1. Scale 1000

2. Explode into edges

3. New Entity > Build > Edge

4. Set 3rd edge method: by edge, strt point, length

5. Create new three edges laying on longer edge.

6. Add necessary lines

7. Create faces

8. Scale 0.001

Have a nice day.

Sheaker

Powered by Ploneboard
Document Actions